COMPGROUPS.NET | Search | Post Question | Groups | Stream | About | Register

MB debug module

  • Follow


I'm working on a multiprocessor architecture targeting spartan 3 starter
kit. (referring to the tutorial XAPP996). I'm stuck in the phase of run
implementation set, because I could not connect the MicroBlaze to the Debug
Module "mdm"!!I used XMD debug by typing the command "connect mb mdm", but
there is an error as follows:
Info: Autodetecting cable. Please wait.
Info: Connecting to cable (Parallel Port - LPT1).
Info: Checking cable driver.
Info: Driver windrvr6.sys version = 8.1.1.0.Info: WinDriver v8.11 Jungo (c)
1997
 - 2006 Build Date: October 16, 2006 X86 32bit SYS 12:35:07, version =
811.
Info: LPT base address = 0378h.
Info: ECP base address = 0778h.
Info: Cable connection established.

JTAG chain configuration
--------------------------------------------------
Device ID Code IR Length Part Name
 1 01414093 6 XC3S200
 2 05045093 8 XCF02S
 ERROR: Could Not Detect MDM Peripheral on Hardware. Check:
        1. If FPGA is Configured Correctly
        2. MDM Core is Instantiated in the Design


So please, if anyone knows the solution, pleaaase my answer!!I'm stuck 
with all my great appreciation!!!

INES	   
					
---------------------------------------		
This message was sent using the comp.arch.fpga web interface on
http://www.FPGARelated.com
0
Reply ines_fr 1/2/2010 12:20:54 PM

comp.arch.fpga 18335 articles. 19 followers.

0 Replies
647 Views

(page loaded in 0.02 seconds)

Similiar Articles:

Parallel port address - comp.soft-sys.matlab
MB debug module - comp.arch.fpga Info: Connecting to cable (Parallel Port - LPT1). Info: Checking cable driver. ... Info: ECP base address = 0778h.

xilinx parallel cable IV - comp.arch.fpga
MB debug module - comp.arch.fpga Info: Connecting to cable (Parallel Port - LPT1). Info: Checking cable driver. ... System Reset Module (v3.00a), Data Sheet DS406 July 23 ...

SSM - comp.dcom.sdh-sonet
MB debug module - comp.arch.fpga I'm working on a multiprocessor architecture targeting spartan 3 starter kit. (referring to the tutorial XAPP996).

Xilinx TCL and Cygwin - comp.arch.fpga
MB debug module - comp.arch.fpga networking with a pc question - comp.unix.solaris gives ... ActiveTcl 8.4.19.4 released - comp.lang.tcl... 4.19.4 ...

unknown devices in JTAG chain - comp.arch.fpga
Hi, I designed a FPGA prototyping board with a Spartan XC2S200E and a XC18V02 PROM. To configure these devices I put a JTAG header on the board and r...

Does PAUSE have any Side Effect ?? - comp.lang.fortran
> If the size of the exe file is any indication, it is ~ 1.5 MB. > > The ... MB debug module - comp.arch.fpga Does PAUSE have any Side Effect ?? - comp.lang.fortran ...

microblaze spi core problem - comp.arch.fpga
I seem to recall doing this helped me debug a similar ... HIGHADDR =3D 0x8340ffff BUS_INTERFACE SPLB =3D mb ... so I can't use the high performance of my W-LAN module.

Old LOC constraint stuck somewhere - comp.arch.fpga
--steve On Oct 15, 4:13=A0pm, "MM" <mb...@yahoo.com ... not compiling EVERYTHING ends up costing hours of debugging ... any file that has the same name as your top level module.

Monitoring gigabit interfaces ? - comp.dcom.sys.cisco
Catalyst debugging - comp.dcom.sys.cisco Monitoring gigabit ... Gigabit Interface Converter (GBIC) Module and Small Form ... 4 Port 1000 MB "Hub" - comp.dcom.lans.ethernet > To ...

Annoying kernel memory leak in U6? - comp.unix.solaris
... 0 0 0 0 module_data ... Other than that, there are (or at least there were) debug ... Page Summary Pages MB ...

MB debug module - comp.arch.fpga | Google Groups
The old Google Groups will be going away soon, but your browser is incompatible with the new version.

Xilinx MicroBlaze and Multimedia Demo. board: Debugging: 8.1.03i ...
... 0x00000000-0x0000ffff) dlmb_cntlr dlmb > (0x00000000-0x0000ffff) ilmb_cntlr ilmb > (0x40600000-0x4060ffff) RS232 mb_opb > (0x41400000-0x4140ffff) debug_module ...

7/23/2012 7:09:43 AM


Reply:
Privacy Policy | All Times Are GMT(UTC) | powered by