f



0,0 not 0,0

hi all,

i have 2 drawings - ground floor and first floor. when i do an ID on a
point on the grid i get the same readings for both drawings however,
when i xref one into the other or both into a new drawing they come in
in different locations. i've checked they're both using world UCS and
the same units. any ideas? i thought with autocad 0,0 was always 0,0?

cheers
rob

0
Coro
7/13/2004 10:56:34 AM
comp.cad.autocad 3784 articles. 0 followers. Post Follow

2 Replies
2478 Views

Similar Articles

[PageSpeed] 1

"Coro, Rob" <RE-Coro@bdp.co.uk> schrieb:

>hi all,
>
>i have 2 drawings - ground floor and first floor. when i do an ID on a
>point on the grid i get the same readings for both drawings however,
>when i xref one into the other or both into a new drawing they come in
>in different locations. i've checked they're both using world UCS and
>the same units. any ideas? i thought with autocad 0,0 was always 0,0?

UCS? INSBASE?

Tom Berger

-- 
ArchTools: Architektur-Werkzeuge f�r AutoCAD (TM)
           ArchDIM  - architekturgerechte Bema�ung und H�henkoten
           ArchAREA - Fl�chenermittlung und Raumbuch nach DIN 277
Info und Demo unter http://www.archtools.de
0
Tom
7/13/2004 11:24:18 AM
insbase, that's the bugger.

thanks tom

rob

-----Original Message-----
From: Tom Berger [mailto:berger@archtools.de] 
Posted At: 13 July 2004 12:24
Posted To: autocad
Conversation: 0,0 not 0,0
Subject: Re: 0,0 not 0,0


"Coro, Rob" <RE-Coro@bdp.co.uk> schrieb:

>hi all,
>
>i have 2 drawings - ground floor and first floor. when i do an ID on a 
>point on the grid i get the same readings for both drawings however, 
>when i xref one into the other or both into a new drawing they come in 
>in different locations. i've checked they're both using world UCS and 
>the same units. any ideas? i thought with autocad 0,0 was always 0,0?

UCS? INSBASE?

Tom Berger

--
ArchTools: Architektur-Werkzeuge fur AutoCAD (TM)
           ArchDIM  - architekturgerechte Bema?ung und Hohenkoten
           ArchAREA - Flachenermittlung und Raumbuch nach DIN 277 Info
und Demo unter http://www.archtools.de

0
Coro
7/13/2004 1:31:55 PM
Reply: