Has any one had any luck bringing in a file from 3d max 6 to SolidWorks.
Have not had any luck with the .stl export.
|
|
0
|
|
|
|
Reply
|
 bryan.solace (1)
|
6/25/2004 6:03:13 PM |
|
Bryan Solace wrote:
>
> Has any one had any luck bringing in a file from 3d max 6 to SolidWorks.
> Have not had any luck with the .stl export.
Try bringing it into Rhino3D, and from there into SolidWorks.
Mark 'Sporky' Stapleton
Charlotte, NC
www.h2omarkdesign.com
|
|
|
0
|
|
|
|
Reply
|
 Sporkman
|
6/25/2004 6:24:28 PM
|
|
It would only fail if the STL is not valid, that is, it's not a closed
(water tight) volume.
So, there maybe a open seam or a facet failed to close?
I'm not sure if Max has repair or check tools but maybe if you reimport
the STL file you could check it?
...
Bryan Solace wrote:
>
> Has any one had any luck bringing in a file from 3d max 6 to SolidWorks.
> Have not had any luck with the .stl export.
|
|
|
0
|
|
|
|
Reply
|
Paul
|
6/25/2004 6:29:13 PM
|
|
Search |
Post Question |
Groups |
Stream |
About |
Register
15031 articles. 
54 followers. 
2 Replies
310 Views
