Keeping alive ISDN 128k to ISP 2 108 (7/6/2003 2:57:13 PM)
Hi, I've just installed a Cisco 801 with a bridged real IP multilink 128k ISDN connection to Demon Internet in the UK. The connection drops every 5 minutes or so. What I would like to do is keep both ISDN ch...
Mr

Question on rate-limit command 1 135 (7/4/2003 7:03:58 AM)
I am having some difficulty understanding how to determine the effect of the burst amounts on peak bandwidth. For an easy math example: rate-limit output 8000000 1000000 1000000 conform-action transmit excee...
John

VPN using IOS Router 0 146 (7/4/2003 12:17:39 PM)
Hi all, I have this simple config that runs on our PIX 506 for our VPN users (see below). How do I configure an IOS Router with IPSEC image to do the same function? Because there are a little bit of difference ...
al

ipv6 - which source address to use? 1 154 (7/3/2003 4:24:56 PM)
Hi, My ipv6 interface has 3 addresses - link-local , site-local & global one. clearly when connecting to global-scope destination, I will use the my global address as the source, but which one to use as a sour...
trigerboim

Algeria voip termination ;need help (sample business plan) 0 221 (7/1/2003 9:13:13 PM)
Hi I am looking for a sample business plan .I am preparing to install a voip termination in Algeria .Can any one help me to have more info. Thanks . ...
juno_52

The proper term for call collapsing is "TBCT" 0 136 (6/25/2003 8:37:21 PM)
In telephony there is a very desirable feature, that is sometimes called "hook-flash" or blind transfer. The above terms apply to analog calls; in ISDN PRI the basic behavior is the same, but the terms are thi...
ramon

Sniffer on 3550 1 130 (6/23/2003 5:40:14 AM)
I need to capture data with bi-directional traffic on vlan 2 on port 12 for catalyst 3550. What is the right command to do this? Thanks. Best Regards, Sam ...
indotears

Telnet restriction with access-list 1 202 (6/23/2003 4:56:09 AM)
Hi all, I need your help to setup an access-list on a 3550 switch. This particular access-list is to restrict all the routers to telnet to 3550, except if it's coming from R1. The switch has 4 vlans on it. I ju...
indotears

Mac address to be pruned every 10 min 0 131 (6/23/2003 5:20:25 AM)
What is the right command to configure catalyst 3550 switch so that MAC address learned on VLAN1 are pruned from the bridge table every 10 minute? Help, please. All Ip addresses and vlan can be made up. Best R...
indotears

I BUY CISCO EQUIPMENT ws-sup720-3bxl,ws-sup720-3b, ws-x6724-sfp, ws-x6704-10ge, ws-x6748ge-tx 1 79 (3/2/2010 2:18:25 PM)
I BUY CISCO EQUIPMENT ws-sup720-3bxl,ws-sup720-3b, ws-x6724-sfp, ws- x6704-10ge, ws-x6748ge-tx I am buying Cisco equipment used and new. See below my want to buy list. I also buy Juniper, Extreme, Borcade, N...
craig.softnet (102)