COMPGROUPS.NET | Search | Post Question | Groups | Stream | About | Register

Getting used/free channel of E1 on AS5400

  • Follow


Hi all,

do any of you use SNMP to get number of free/used channels in E1 on 
AS5400? Which variable do you pool to do that? I've looked in call-
tracker mib but seems that results are not equal to output from "show 
call active voice".

Thanks,

-- 
Ivan

*** User rot13 to see my eMail address ***
0
Reply Ivan 7/14/2005 7:18:40 AM

comp.dcom.sys.cisco 24945 articles. 24 followers.

0 Replies
228 Views

(page loaded in 0.169 seconds)

Similiar Articles:

Far End Block Errors Detected - comp.dcom.sys.cisco
Hi there, I am getting Far End Block Errors ... switch) on the out-of-band management channel. This means the other end of the E1 ... arranges the matter so that an error-free ...

ima UP and Running but errors on single atm - comp.dcom.sys.cisco ...
Datagram Size: 4496 PLIM Type: E1, TX clocking: LINE Cell-payload ... 0x63BF824), em_blk(0x63BF8E4) tx_buf_desc(0x65633C0), tx_free_desc_idx (1023) MXT5100 sub_channel ...

Something bad happened to my gfortran installation - comp.lang ...
After months of trouble-free use, I installed the most ... is from the ISO_C_BINDING module which wasn't USEd in ... =A0 =A0 =E1?" > L?" =A0 =A0 @?" > =FF?" =A0 =A0 =C9?"

Cisco AS5350 and Cisco AS5400 Universal Gateway Software ...
On a Cisco AS5350 or Cisco AS5400, you can allocate the available channels for channelized E1 and T1 in the ... The Free Channel Mask: 0x807FFFFF

Cisco AS5400 Series Universal Gateway Data Sheet [Cisco AS5400 ...
•The main CPU in the Cisco AS5400 is also used in the Cisco ... for CAS, PRI, or IMTs, and include channel ... signaling is available for both T1 and E1 trunks. Cisco AS5400 ...

7/12/2012 8:18:47 AM


Reply:
Privacy Policy | All Times Are GMT(UTC) | powered by