OSPF routing over DMVPN tunnel ... - comp.dcom.sys.cisco ...Here's part of the config of the hub router: interface Tunnel3 ip address 192.168.63.65 ... nhrp map multicast dynamic ip nhrp network-id 2001 no ip route-cache ip ...
Spoofing on ADSL dialer interfaces - comp.dcom.sys.cisco ...Hi, have a cisco router setup with 2x 2m adsl lines and configured for load ... interface ATM0/1 no ip address ip load-sharing per-packet no ip route-cache no ip ...
Tunnel 0 is UP, Line Protocol is down - comp.dcom.sys.cisco ...... up a VPN between two routers. Here is the configs for both routers: Router-1 ... interface FastEthernet0/0 ip address 122.128.223.122 255.255.255.0 ip route-cache flow ...
ISDN Outgoing calls ! - comp.dcom.sys.ciscoHi Group, I have configured a 2801 router with 4 ISDN lines. I am observing a ... voice voice isdn sending-complete isdn skipsend-idverify no clns route-cache ! ip ...
VPN Ping returns 1 packet - comp.dcom.sys.ciscoI can ping the responding router's LAN IP with 100% success from the initiating LAN. ... Might want to try alternate switching methods. i.e. "no ip route-cache", to rule ...
MLPPP vs. Cisco CEF - comp.dcom.sys.ciscoAlso, with a Cisco 36xx series router what is the ... months ago I was looking at some of the key performance ... bundle ip address 1.2.3.4 255.255.255.252 ip route-cache ...
cisco commands for checking for DOS attack - comp.dcom.sys.cisco ...... is Attacking my :router. - Check your cpu load against your regular load - show your ip routes and see if you have an abnormal number of them - show your route-cache and ...
Need help adding device to new vlan - comp.dcom.sys.cisco ...... desirable no ip address shutdown ! interface Vlan1 no ip address no ip route-cache ... Need to map a port on a 1700 router - comp.dcom.sys.cisco ... Need help adding ...
Bonded T1 - 2xT1 - Upload Help - comp.dcom.sys.cisco... equal cost routes to both interfaces, and (2) CEF enabled on the router. Do "show ip route ... no ip proxy-arp encapsulation frame-relay IETF no ip mroute-cache ...
Cisco 828 and duplex settings - comp.dcom.sys.ciscoI have an 828 router and I need to change the duplex on one of the ethernet ports (not fast ethernet, just ethernet). When I go into the interface I ...
The ip route-cache command – Bury the hatchet seriesRouter(config-if)#ip route-cache ? cef Enable Cisco Express Forwarding ... CEF-switched PBR has better performance than fast-switched PBR and ...
Cisco IOS Switching Services Command Reference, Release 12.3 ...The ip route-cache command with no additional keywords enables fast switching. ... Router(config-if)# ip route-cache same-interface
Search |
Post Question |
Groups |
Stream |
About |
Register
ralf.huelsmann
merv
23 followers. 
1 Replies
112 Views
