Hello, I have an Omnipro 2 with a OnQ 4 branch ALC board. I installed
it just like the instructions said. I dont know how to control it using
the dealer software for Windows ver 2.4a. The status light on the alc
board is blinking. How do you tell the Omnipro the the expansion alc
board is installed?

THANK YOU

JEFF

Hi Jeff,

Have you tried asking this question at:

http://www.worthingtonsolutions.com/cgi-bin/yabb/YaBB.cgi?board=HAI_Prog

They have some pretty smart folks over there.

--
Bobby G.

<jeffd@paradisegreetings.com> wrote in message
news:1117088410.373243.310840@z14g2000cwz.googlegroups.com...
> Hello, I have an Omnipro 2 with a OnQ 4 branch ALC board. I installed
> it just like the instructions said. I dont know how to control it using
> the dealer software for Windows ver 2.4a. The status light on the alc
> board is blinking. How do you tell the Omnipro the the expansion alc
> board is installed?
>
> THANK YOU
>
> JEFF
>