e_engineer00 User Profile

e_engineer00's articles:

Items(6) /1
Problem with OMAP5912 usb device controller's endpoint configuration 0 32 (11/8/2004 7:58:20 AM) comp.arch.embedded hi, 1- i am facing problem in configuration of endpoints in USB device controller on OMAP5912. When i write the configuration registers (register number 0x20 to 0x3F of device controller), value is not displa... e_engineer00
Problem with OMAP5912 usb device controller endpoint configuration 0 23 (11/8/2004 7:55:21 AM) comp.dsp hi 1- i am facing problem in configuration of endpoints in USB device controller on OMAP5912. When i write the configuration registers (register number 0x20 to 0x3F of device controller), value is not display... e_engineer00
Problem with OMAP 5912 USB device controller endpoint configuration registers. #2 0 30 (11/7/2004 9:14:56 AM) comp.arch.embedded hi, i am developing firmware for OMAP 5912 USB device controller on OSK5912 board. i am finding difficulty with writing the OMAP USB device endpoint configuration register (register 0x20 to 0x3F). Following is... e_engineer00
Problem with OMAP 5912 USB device controller endpoint configuration registers. 0 29 (11/6/2004 1:23:24 PM) comp.dsp hi, i am developing firmware for OMAP 5912 USB device controller on OSK5912 board. i am finding difficulty with writing the OMAP USB device endpoint configuration register (register 0x20 to 0x3F). Following is... e_engineer00
Need help about SH4 board KZ-SH4PCI-01 with KZP-01 by KMC 0 34 (12/5/2003 4:57:52 AM) comp.arch.embedded hello, i need some user manual for the SH4 board KZ-SH4PCI-01 on the motherboard KZP-01 developed by KMC. i have not found any information about these boards on internet. Only some information is available on ... e_engineer00
Need help in capturing serial data using FPGA and ethernet interface 0 176 (7/2/2003 6:52:26 AM) comp.arch.fpga hello, i want to capture 2 mbps serial data stream through my ethernet card. i already have a Virtex FPGA based hardware and I want to add it this data logging funtionality. I want to use FPGA to convert the r... e_engineer00